Contact Us

Tel:+8615152288398

Fax:+86-510-86292857

Mob:+8615152288398

E-mail: sunny@yuanfangmach.com

Add: No.8 Kaitai Rd., Nanzha Street, Jiangyin City, Jiangsu Province, China

web:http://www.chamferingmachinechina.com

Home > Exhibition > Content
Several Common Problems and Solutions in Chamfer Machining Jan 04, 2018

Although the chamfer machine has excellent performance, but in the course of a long time may also be some unusual problems. Next, we analyze some of the more common problems in chamfering machining and hope to provide some help to our users and friends to better solve these problems.

 

One of the more common first problems is the presence of scratches on the bevel of the product, including for two reasons, one for the broken tool and the other for scratch. So encounter such a problem, we should promptly replace the tool, and to iron clean up. Another common problem is that the obtuse edges of the chamfering machine are irregularly regular, while thick and thinner on one side.

 

After analysis, we can understand that the reason for such problems arises mainly from four aspects:

1, may be due to chamfering machine driven roller height is not enough;

2, It may be due to driven roller contact surface wear or bearing damage;

3, it may be due to the spring force is small or damaged; Fourth, it may be due to offset the clamping device.

 

For the above analysis of the problem, the measures should be taken to address:

1, appropriate to adjust the chamfering machine driven roller height;

2, replace the driven roller or bearing;

3, adjust the spring to enhance the elasticity or replace the spring;

4, adjust the fixture concentricity. In addition, in the actual production process, may also face the problem of incomplete end, the main reason is caused by pipe ends.

 

After the overhaul, if it is determined to be due to the chamfering machine stroke is too small, then the need to increase the production requirements of the appropriate feed stroke. In addition it may also be due to excessive inclination deviation of the chamfering machine caused, and even need to cut after the first processing.http://www.chamferingmachinechina.com/